Weighing just 5 pounds (2.3kg), about half the weight of the original Ronin, the slimmed down Ronin-M is small enough to fit into your backpack and take anywhere, yet strong enough to support camera setups weighing up to 8 pounds (3.6kg).

1x Ronin M

1x 1-Channel Focus Kit for the use of a single motor with the Slave Controller Thumbwheel.

Built-In Functions

1. Three Operation Modes
   · Underslung Mode
   · Upright Mode
   · Briefcase Mode
2. Built-in, independent IMU module
3. DJI Specialized Gimbal Drive Motors with Encoders
4. Bluetooth Module
5. USB Connection
6. 2.4GHz Receiver
7. Temperature Sensor
8. DJI Advanced 32-Bit DSP Processor
9. D-Bus Receiver Supported 

Camera Tray Dimensions

Maximum depth at center of mass on camera base plate: 120mm
Maximum height measured from top of camera base plate: 195mm
Maximum width: 160mm

Accessory Power Connections

12V Regulated P-Tap x 2, USB 500mW x 1, DJI Lightbridge x 1

Weight

2.3kg (5.07lb) fully loaded with handlebar

Gimbal Dimensions

500mm(W) x 210mm(D)x 420mm(H)

Load Weight (Reference Value)

3.6kg (8lb)